Today is a little tour back to the early 1980s when Mattel released the DUNGEONS & DRAGONS Computer Labyrinth Game. [Cameron Kaiser] was dealing with a few boxes of old stuff when he came across the game. Luckily for us, he decided to do a complete teardown and a comprehensive review more than 40 years after it came out.
The game itself is pretty simple. You and a friend are characters on the board, navigating an eight-by-eight maze. As you move through the labyrinth, a microcontroller emits twelve audio cues telling you what you’ve run into (walls, doors, treasure, and so on). The eight buttons on the side allow you to hear the different tones to know what they mean, as we imagine even the most well-written manual might struggle to describe that. In addition, the pieces are diecast metal, which allows the game to detect where the pieces have been placed.
With considerable difficulty, [Cameron] opened the game to reveal a membrane keyboard pad to detect the different pieces. The actual PCB is relatively small, holding only a single 2N2222 transistor, a couple of resistors and capacitors, and one 28-pin Texas Instruments DIP. While the markings on the chip say M34012, it is a tweaked TMS1100, a descendant of the first microcontroller. It is a PMOS part, allowing it to run directly off a 9-volt battery with little to no regulation. Mattel needed something cheap and customizable to mass produce, and TI had just the design. You could hand them a ROM, an instruction decoder PLA, and an output PLA and get back a cheap little chip you could get a million of. [Cameron] has an ..
Support the originator by clicking the read the rest link below.
