Adding a resin printer to one’s workbench has never looked so attractive, nor been so affordable. Complex shapes with effortlessly great detail and surface finish? Yes, please! Well, photos make the results look effortless, anyway. Since filament-based printers using fused deposition modeling (FDM) get solid “could be better” ratings when it comes to surface finish and small detail resolution, will a trusty FDM printer end up retired if one buys a resin printer?
The short answer is this: for users who already use FDM, a resin-based stereolithography (SLA) printer is not likely to take over. What is more likely to happen is that the filament printer continues to do the same jobs it is good at, while the resin printer opens some wonderful new doors. This is partly because those great SLA prints will come at a cost that may not always justify the extra work.
Let’s go through what makes SLA good, what it needs in return, and how it does and doesn’t fit in with FDM.
When SLA Is Good, It’s REALLY Good
Objects with organic curves and no real “up” or “down” are much better suited to SLA than FDM.
The sweet spot for resin printing is this: small objects with smooth finishes, organic curves, and surface details. With SLA, these objects print more reliably and at a consistently higher quality than with FDM — as long as the operator does a good job with layout and support placement, anyway.
A big reason for this is that SLA does not produce layer lines the way FDM does. FDM prints are notorious for visible layer lines, and those lines are at their worst when spread acro ..
Support the originator by clicking the read the rest link below.
